ergoCentric upCentric Guide De L'utilisateur page 11

Plug Handset into the Control Box and run
Step 12A:
( PART L ) ( PART J )
cord out to the desired location. Run the wire between the frame and
the tabletop through small inlet hole and screw down to the underside
of the tabletop.
Plug
Step 12B:
Power Cord
( PART K )
12A
into the back of the
Control Box
( PART J )
and run it between
the frame and the
tabletop through the
small inlet hole.
Step 13:
Center the frame on the tabletop
and attach by inserting Screws in
( PART B )
the designated holes.
Step 14:
Attach/Connect all (5) cords/plugs to the
control box.
Attach feet to the ends of each
Step 15:
( PART N )
leg using Bolts .
( PART A )
11