Brew Monk TITAN Mode D'emploi page 25

Step 2
You can adapt the overfl ow pipe according to the amount of malt recommended for your
recipe. For that adjust the telescopic pipe (D) to the desired height.
2.3.2 Filling the Malt Pipe with Malt
Step 1
Insert the assembled overfl ow pipe with malt screen into the malt pipe.
Step 2
Extend the telescopic overfl ow pipe (D) to its maximum height.
Step 3
Place malt pipe (8) in the Brew Monk (1).
Fill with water according to recipe.
Step 4
Place the black cap (13) and fi ll the malt pipe (8) with malt.
Step 5
Adjust the height of the telescopic overfl ow pipe (D) to 3 to 4 cm above the water volume.
Step 6
Slide the upper malt screen with the handles onto the malt.
Instruction Manual Brew Monk Titan - EN
25