Brew Monk TITAN Mode D'emploi page 24

EN - Instruction Manual Brew Monk Titan
• The blue valve, located on the circulation pipe, closes the ball valve when in horizontal
position; and opens the ball valve in vertical position.
• Switch off the pump when you close the blue valve for longer than 5 seconds.
• Always close the blue valve and switch off the pump before removing the curved pipe (11).
• Do not run the pump during wort boiling.
• It is not recommended to use the pump for pumping the wort after cooling, as there is no
fi lter on the pump inlet. This can cause brew debris to enter the pump, potentially blocking
and damaging the system.
2.2 Bazooka Filter Assembly
Attach the bazooka fi lter (12) on the male thread inside the Brew Monk and screw the bazooka
fi lter on (see picture below).
2.3 Overfl ow Pipe Assembly
2.3.1 Malt Pipe Assembly Outside the Brew Monk
Step 1
24
A
B
A
C 1 x top malt screen
B
1 x bottom malt screen
C
1 x nut
D
D
1 x telescopic overfl ow pipe
Place male threaded
overfl ow pipe (D) through
bottom malt screen (B) and
attach with the nut (C).