LOTRONIC AFX LiGHT SPARKULAR-MINI-FALL Manuel D'utilisation page 5

Attention :
The first group machines correspond to DMX address "1", the second group DMX address is "3",
the third DMX address is "5", remote controller controls 3 group machines. It also can set all unit's
addresses as "1".
When the lamp is not lit or become weak on the remote controller, replace the battery. It is better
to take battery out when transporting to prevent consumption of battery power by unmeant press
of button.
BATTERY MODEL 12V 23A
When the machine is occasionally not working, may be caused by interference, please press the
start button again.
Wireless control is easily influenced by interference, it is recommended to stay as close as possible
to the machine when using the remote control, and machines cannot use metal shielding.
MASTER MODE (REQUIRES XLR CABLES):
In case of strong interference, the Master-slave mode might be a solution. Set the DMX address of
the first unit to "1++". The address of this unit is "1" but it can also supply a DMX output signal and
become a Master. Daisy-chain the other units via XLR cables. The master unit receives the signal
from the remote control and sends it to all others of the chain.
SPECIFICATIONS
Dimensions
Weight
Input voltage
Working Power
Working Temperature
Casing
Hopper capacity
Granulate consumption
Fall length
Interface
IMPORTANT NOTE: Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local
authorities or your dealer about the way to proceed.
150 x 160 x 240mm
3kg
220-240VAC, 50/60Hz
130W
-10°~ 50°C
Anti-flame ABS
280g
15g/min.
3-4m (large), 2-3m (medium), Depends on the type of composite Ti used
Double DMX input interfaces, double AC power interfaces
www.afx-light.com
5 EN