Homelite HBV2500S Manuel D'utilisation page 12

EN
DE
FR DE ES
FR EN ES
Deutsch(Übersetzung der originalen Anleitungen)
Fig 2
11. Lower tube
13. Upper tube
Fig 3
12. Tube connection screw hole
Fig 4
16. Rib
17. Wheel bracket
Fig 5
18. Screw
Fig. 6
19. Screw
Fig 7
20. Strap
21. Hook
Fig 8
7. Collection bag connector
Fig 10
2. Trigger
Fig 11
22. Blow mode selected
Fig 13
23. Vacuum mode selected
ASSEMBLY
UNPACKING
Carefully remove the product and any accessories
■
from the box.
Inspect the product carefully to make sure no
■
breakage or damage occurred during shipping.
Do not discard the packing material until you have
■
carefully inspected and satisfactorily operated the
product.
If any parts are damaged or missing, please call your
■
Homelite service centre for assistance.
The blower vac is supplied with some components
■
not assembled. To assemble these, proceed as
follows:
1. Assembly of the tube (Fig. 2-5)
Insert the lower tube (11) into the upper tube(13)
■
and align the screw hole (12) so that the screw can
fit through. Fix the tubes together by tightening the
IT PT NL SV DA NO
IT PT NL SV DA NO
English(original instructions)
FI HU CS RU RO PL
FI HU CS RU RO PL
screw.
Slide the wheel bracket (17) over the lower tube as
■
shown in figure 4. Align the screwhole and securely
fasten the screw (18) to attach the wheel bracket to
the lower tube.
2. Attaching the tube to the motor housing (Fig. 6)
Slide the tube which you assembled in step 1 over
■
the the motor housing.
Insert and tighten screw (19) to fix blower tube on the
■
product.
3. Attaching the collection bag (Fig. 7-9)
Connect the strap (20) of the bag to the hook on the
■
motor housing (21)
Attach the plastic plug-in connector on the bag to the
■
motor housing outlet until it clicks into its position (fig.
8)
Attach the strap on the lower end of the collection bag
■
to the hook on the tube (8)
To disconnect, perform all above steps in reverse
■
order
4. Attaching the shoulder strap (Fig. 1)
Clip the shoulder strap (1) into the shoulder strap
■
mounting hook (15)
Adjust length for comfortable use
■
OPERATION
INTEND USE:
This blower vacuum is intended for cleaning in dry
areas(blow mode and suction mode) in domestic use.
Potential risk may occur if not for such use.
SWITCHING BETWEEN SUCTION MODE AND BLOW
MODE (Fig. 11-12)
Warning:
Always ensure that your unit is switched off and
has fully stopped before changing the mode of
operation. Do not force the quick change lever.
It should move smoothly without resistance. If
you encounter problems, disconnect from power
supply and clean the lever mechanism.
For blow mode:
Switch the quick change lever(5) to point at the blow
■
symbol (22) (see fig. 11)
For suction/vacuum mode:
Switch the quick change lever (5) to point at the
■
vacuum symbol (23) (see fig. 12)
10 10
SL HR ET LT LV
SL HR ET LT LV
SK BG
SK BG