Battery Recycling - Panasonic EY7441 Instructions D'utilisation

EY7443
EN
The battery protection feature may
●
activate when a high load is abruptly
placed on the motor, even if ample
battery charge remains. In this case, both
the battery low warning lamp and LED
light will fl ash (EY7443, EY74A1).
If both the battery low warning lamp and
●
LED light flash, reduce the force with
which you are pushing on the driver or,
if using a drill driver, adjust the speed
switch to a lower setting (EY7443,
EY74A1).
If the tool does not switch between HIGH
●
and LOW speed operation in AUTO
mode, the motor will stop and the battery
low warning lamp and the overheat
warning lamp will alternately flash. It is
not breakdown.
If both lamps alternately flash, depress
●
the trigger again. (EY7443)
[Battery Pack]
For Appropriate Use of
Battery Pack
Li-ion Battery Pack
For optimum battery life, store the Li-
●
ion battery pack following use without
charging it.
When charging the battery pack, confi rm
●
that the terminals on the battery charger
are free of foreign substances such as
dust and water etc. Clean the terminals
before charging the battery pack if any
foreign substances are found on the
terminals.
The life of the battery pack terminals may
be affected by foreign substances such
as dust and water etc. during operation.
When battery pack is not in use, keep it
●
away from other metal objects like: pape
clips, coins, keys, nails, screws, or other
small metal objects that can make a
connection from one terminal to another.
Shorting the battery terminals together
may cause sparks, burns or a fi re.
EY971074416_Book.indb 16 EY971074416_Book.indb 16
When operating the battery pack, make
●
sure the work place is well ventilated.
When the battery pack is removed from
●
the main body of the tool, replace the
battery pack cover immediately in order
to prevent dust or dirt from contaminating
the battery terminals and causing a short
circuit.
Battery Pack Life
The rechargeable batteries have
a limited life. If the operation time
b e c o m e s e x t r e m e l y s h o r t a f t e r
recharging, replace the battery pack
with a new one.

Battery Recycling

ATTENTION:
For environmental protection and
recycling of materials, be sure that it
is disposed of at an officially assigned
location, if there is one in your country.
[Battery Charger]
Charging
CAUTION:
If the temperature of the battery pack
●
falls approximately below −10°C (14°F),
charging will automatically stop to
prevent degradation of the battery.
The ambient temperature range is
●
between 0°C (32°F) and 40°C (104°F).
If the battery pack is used when the
battery temperature is below 0°C (32°F),
the tool may fail to function properly.
When charging a cool battery pack
●
(below 0°C (32°F)) in a warm place,
leave the battery pack at the place and
wait for more than one hour to warm up
the battery to the level of the ambient
temperature.
Cool down the charger when charging
●
more than two battery packs consecutively.
Do not insert your fingers into contact
●
hole, when holding charger or any other
occasions.
- 16 -
2014/10/10 14:26:05 2014/10/10 14:26:05