in-lite FISH EYE 100X100 Manuel D'utilisation page 4

GB
Contents
1x Fish Eye 100x100 (WW) 12 V/1.5 W
Dimensions 100 x 100 mm / 3.9 x 3.9 inches,
overall height 60 mm / 2.4 inches
1x Easy-Lock
Material
Stainless steel, impact-resistant polycarbonate.
Please read the following instructions before installing. You are ad-
vised to keep these installation instructions in a safe place.
Although a 12 V system is safe, we advise you to have a qualified
electrician check the installation.
Usage
Integrated atmospheric lighting suitable for illuminating plants (small
trees, ornamental trees) or as lights marking a pathway, patio, pond
edging, driveway etc. The fixture is equipped with a light unit that
can be rotated through 360°. To direct the "Fish Eye" you must first
slightly loosen the 3 socket screws in the top plate. Turn the eye to
the desired position and then fix it in place by tightening the socket
screws.
Caution! Do not overtighten the socket screws.
Lamp
The fixture is equipped with a high-quality LED lamp. These lamps
have a long life (about 50,000 hours) and a high light output. On the
other hand, their power consumption and the heat produced are
extremely low.
Important!
Never connect the low-voltage cable directly to a 100-240 V power
source. It is only suitable for use in combination with a 12 V low-
voltage system. This product should only be used within the in-lite
system. Use of products other than those made by in-lite will invali-
date the warranty.
Enjoy your garden illumination.
GB
Connection of the fixture to 12 V
Because LEDs are used as the light source, the fixture is ready for
immediate use and you do not have to fit a bulb first. This fixture
can be built into various types of paving such as concrete or natural
stone.
Step 1
Replace a 100 x 100 mm / 3.9 x 3.9 inch stone with this fixture or, in
the case of large, unbroken surfaces, saw out a 100 x 100 mm / 3.9
x 3.9 inches piece. The fixture can then be placed directly on the
underlying sand bed.
Step 2
Join the connector to the main cable. Ensure that the cable lies
straight in the cable channel so that each part of the cable runs pre-
cisely over one of the contacts. For 14/2 cables, use the insert to help
you do this. First place the insert in the connector under the cable.
Now turn the threaded cap onto the connector. This will cause the
contacts to be pushed through the insulation on the cable. (Fig. 1)
Step 3
Connect the power cable to the fixture by connecting the mini-
connector. (Fig. 2)
If the lamp does not work correctly, check that the connector is
properly connected to the main cable. Do the same for the mini-
connector. Repeat steps 2 and 3. When the fixture is connected to
the main cable, also check that the contacts are not bent. If you have
any problems, contact your dealer.
General maintenance advice
We advise wiping the fixture down at least once a year using a clean
cloth and warm water.