Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION OF THE APPLIANCE
Sighting of the appliance
• Place the freezer in a location with a firm base. In order to prevent
vibration and noise, the freezer must be leveled by adjusting the front
feet.
• Choose a well ventilated location with no less than 10cm clearance
around the freezer.
• Site the freezer away from direct sunlight and heat sources such as an
oven or boiler.
Warning: This appliance must be earthed.
Reversing the door
This freezer has been built with the door hinges on the right. If you want
to change the opening direction, please follow the instruction below:
1. Remove the four screws(1)(2) and take away the top.
2. Remove the two screws(3) that hold the upper hinge(4) and take
away the upper hinge(4).
3. Lift the door and place it on a padded surface to prevent scratching
it.
4. Remove the three screws(5) that hold the lower hinge(6) and make
sure to remove the lower hinge(6).
5. Remove the adjustable leg(8) and transfer it to right side.
6. Remove the bolt-pin(7) and reverse the direction of lower hinge(6).
Install the lower hinge (6) into left side with three screws (7).
7. Insert the bolt-pin(7) to the lower hinge(5).
8. Remove the hinge pin (9) that is in the bottom of door. At the other
side of door, insert the replacement hinge pin that is supplied with the
appliance.
9. Set the door to its place and make sure the door seat at the lower
hinge (6).
10. Fix the upper hinge (4) with the two screws (3) and the top with four
screws(1)(2)
-13-
Publicité
Chapitres
