Base Settings; Base Setting Access; Tone Dialling Switch Over - Geemarc AmpliDECT250T Notice D'utilisation

Base Settings

1 - Base settings access
Each time you want access to the base setting , you will have to enter PIN code.
Use ▲and▼to select "BS setting"
Press OK
"Base PIN" is displayed
Enter 1590 or your new code if you changed it
Press OK
Now you are in the base menu
2 - Tone dialing switchover
Your AmpliDECT200 has been set to tone dialing at the factory, but if your network
requires pulse dialling, you will have to change the mode .
Use ▲and▼to select "BS setting"
Press OK
"Base PIN" is displayed
Enter 1590 or your new code if you changed it
Press OK
Use ▲and▼to select "Dial Mode"
Press OK
Use ▲and▼to select "Pulse"
Press OK
Press C twice or once to return to standby mode ...
22