Receiving Unit Functional Control - ELCA MAGO Manuel D'utilisation

ENG man MAGO-EVO 03

8.3 RECEIVING UNIT FUNCTIONAL CONTROL

Follow the diagram below (starting from the top left corner) to solve or identify the problem.
IS THE RECEIVER
POWERED?
YES
IS THE POWER
LED ON THE
RECEIVER ON ?
YES
RUN THE ENABLE
SEQUENCE ON THE
TRANSMITTER
(default start-G-start)
DOES THE
ENABLE LED ON
THE RECEIVER
FLASH QUICKLY?
YES
PRESS START ON
THE ENABLED
TRANSMITTER
NO
ARE THE 2 LEDs OF
THE STOP RELAYS
BOTH ON ?
YES
DO THE START AND
ACTIVE KEYS LEDs
SWITCH ON ?
NO
NOTE: If the radio remote control operates in a discontinuous manner, see section:
REPEATED RADIO CONNECTION FAILURES in Paragraph 8.1.
NO
SUPPLY
POWER.
NO
NO RADIO LINK
NO
(see Paragraph 8.1)
INCORRECT
YES
OPERATION
(see Paragraph 8.1)
- Page 20 -
MAGO-EVO Radio Remote Control
CHECK THAT THE
POWER SUPPLY CABLE
IS CORRECTLY
CONNECTED
NO
IS VOLTAGE PRESENT
AT THE POWER
SUPPLY TERMINALS
ON THE RECEIVER?
YES
CONTACT
SERVICE.
NO
IS RADIO REMOTE
CONTROL WORKING?
YES
CHECK
COMPLETED
YES
IS RADIO REMOTE
CONTROL WORKING?
NO
CONTACT
SERVICE.