Troubleshooting; Type Of Trouble - ELCA MAGO Manuel D'utilisation

ENG man MAGO-EVO 03

8. TROUBLESHOOTING

8.1 TYPE OF TROUBLE

- RADIO CONNECTION FAILURE: The radio connection is not activated when Start is pressed.
The radio connection is active and working when the green LED blinks slowly (1 flash every second). The lighting of the
red blinking LED indicates low battery (1 hour remaining).
SIGNAL
No LED switches on
Green LED fixed
seconds, then red LED for 1
second, then the transmitter
switches off.
Red LED for 1 second, then
the transmitter switches off.
Green LED fixed for 10
seconds then blinks twice
every 2 seconds.
Green LED blinking and red
LED on fixed for 10 seconds,
then the transmitter switches
off
Red LED fixed
Green LED blinks rapidly.
Green LED fixed and red LED
blinks twice every 2 seconds.
/
- REPEATED RADIO CONNECTION FAILURES
Green LED blinks rapidly.
/
- OPERATING ERROR:
ONE OR MORE CONTROLS
FAIL TO ACTUATE THE
CORRESPONDING
MOVEMENT.
POSSIBLE CAUSE
LOW BATTERY
for 5
ENABLE SEQUENCE NOT
ENTERED
INCORRECT ENABLING
SEQUENCE
SYSTEM OUTSIDE
OPERATING RANGE
RECEIVER OFF
OR NOT WORKING
TRANSMITTER IS NOT
COUPLED TO ANY
RECEIVER
STOP MUSHROOM
BUTTON PRESSED
RADIO INTERFERENCE
RECEIVER ERROR
SYSTEM IMPROPERLY
INSTALLED
For any causes other than
those listed above
RADIO INTERFERENCE
EXTERNAL ANTENNA
(if fitted)
SYSTEM IMPROPERLY
INSTALLED
For any causes other
than those listed above
DAMAGED FUSE
COMMAND
TRANSMISSION FAILED
WRONG WIRING
CONNECTION
SUGGESTED REMEDY
Recharge the batteries (see Chap. 6)
Enter the transmitter's enabling sequence (Par. 2.3).
Enter the transmitter's correct enabling sequence
(Par. 2.3).
Ensure that operating distance is within the allowed
range (see Chap. 3) and that system has been installed
correctly (see Paragraph 2.5)
Receiver shut-down will cause the transmitter to switch
off as well.
Power on the receiver (see Par. 8.3)
Perform the coupling procedure (see Chap. 7) for the
replacement of the transmitting unit.
Release the STOP mushroom button.
Ensure there are no other similar systems or sources of
noise such as radio bridges or transmitters. Switch the
transmitter off and back on again.
Switch the transmitter unit off and on again. Contact the
technical assistance if the problem is not resolved.
Check system for proper installation (receiving unit
position, metal obstacles,...)
(see Par. 2.5)
See Par. 8.2
Ensure there are no other similar systems or sources of
noise such as radio bridges or transmitters. Switch the
transmitter off and back on again.
Check for correct position and connection.
Check system for proper installation (receiving unit
position, metal obstacles,...).
(see Par. 2.5)
See Par. 8.2
Check the fuses inside the receiving unit. (see Par. 5.1)
Ensure that the receiver indicator light corresponding
to the command actuated from the transmitter turns on.
(see Par. 5.1)
Check wiring in the receiving unit. (see Par. 5.2)
- Page 18 -
MAGO-EVO Radio Remote Control