Battery Charger; Battery Charger Usage - ELCA MAGO Manuel D'utilisation

ENG man MAGO-EVO 03

6. BATTERY CHARGER

6.1 BATTERY CHARGER USAGE

The transmitter must be recharged in an environment in which the temperature ranges between 0°C and 40°C. this will
obtain maximum performance in terms of charging capacity and useful life of the battery.
Check that the electrical connection poles are clean and dry before connecting the charging system.
Indicator lights
When connecting the charging system, the red LED on the transmitter will light to indicate that charging has started.
Pressing and holding the START button, the white LEDs 1, 2 and 3 will light progressively depending on the charge status
of the battery; only LED 3 lit indicates that the battery is low, LED 1, 2 and 3 lit indicate that the battery is fully charged.
When the battery is fully charged, the red LED turns off and the green LED lights.
The full charging process lasts about 4 hours.
The lithium polymer batteries allow a rapid charging process in the initial part of charging. The graph below shows that
75% of the useful charge is obtained in two hours of charging, equivalent to about 30 hours of run time.
A charge of just 20 minutes can ensure approximately 4 hours of run time.
It is advisable to always keep the batteries fully charged to be able to ensure full effectiveness.
Avoid leaving the batteries discharged for long periods.
Charge the batteries at least once a year.
Connecting the charging system
Removing the charging system
100,00%
75,00%
50,00%
12,00%
0,00%
0 20
Charge time
80 120
- Page 14 -
MAGO-EVO Radio Remote Control
Click
240