TMB TOP Série Manuel D'utilisation Et D'entretien page 14

follow them and keep them for future use or for possible resale of the appliance.
•
• Failure to follow the operating instructions and safety standards can cause damage to
the appliance and present a danger to the user and other people.
• Any transport damage should be reported immediately to your dealer.
SYMBOLS USED IN THE MANUAL
Open book symbol with an "i":
Indicates the need to consult the instruction manual.
Open book symbol:
Tells the operator to read the manual before using the appliance.
Covered place symbol:
the operations preceded by this symbol must always be carried out in a dry, covered area.
Symbol i:
Indicates additional information for the operator, to improve the use of the device.
ENVIRONMENT PROTECTION
All packaging is recyclable. The packages must not be discarded in household waste, but
delivered to the relevant collecting centres.
Old appliances contain valuable recyclable materials and must be delivered to the
relevant collection centres. Batteries, oil and similar substances must not discarded in
the environment. Please dispose of old appliances via the separate collection systems.
TECHNICAL DATA TABLE KEY
Type of vacuum:
W=Dust; WD= Wet & Dry
Collection tank material:
PP=Polypropylene ; Acc= Steel
Number of vacuum motors.
Number of stages of the vacuum motor:
Single Stage= 1 stage; Double Stage= 2 stages
O and kPa).
2
3 /h).
COMPLIANT USE
WARNING: The appliance is not suitable for vacuuming powders that are harmful to health.
•
• This appliance is suitable for commercial, professional and industrial use, such as workshops,
industries, schools and hotels.
• The ambient temperature must not exceed 40° C.
PARTS OF THE APPLIANCE
1. Vacuum head.
2.
3. Vacuum motor control switch.
4. Power cable.
5. Power cable plug.
6. Power cable support.
7.
8.
9.
10.
11. Vacuum cap fastening hook.
12. Collection tank.
13. Nozzle.
14. Vacuum hose release button .
15.
16. Collection tank support trolley.
17. Pivoting wheel.
18. Rear wheel.
19. Trolley control handlebars .
INITIAL OPERATION OF THE APPLIANCE
Before beginning to work, it is necessary to:
1.
N.B. :
2. Open the outer box.
3. Remove the accessories from the box and carefully lay them on the ground.
4. Remove the appliance from the packaging.
N.B.:
CAUTION
DANGER
5. Insert the vacuum hose into the nozzle on the collection tank, press the button on the nozzle
6. Connect the extension pipe to the vacuum hose.
7. Choose the most suitable attachment for the work to be carried out and connect it to the
extension pipe.
Dry cleaning:
1.
).
2. Check that the plug on the power cable is connected to the power supply socket, otherwise
disconnect it.
WARNING:
3.
N.B.:
N.B:
4.
5. Plug the power cable into the mains socket.
ATTENTION:
6.
N.B.:
7. Start work.
else "CARPET FLOORS". Proceed with the vacuuming.
N.B:
ATTENTION:
If when working a reduction in the vacuuming power is noted or the noise of the appliance
becomes louder:
•
• Remove the plug from the power socket.
WARNING:
•
•
N.B:
• Empty the collection tank.
N.B:
•
• Start work again.
14
).
).
).
).
).
).
).
).