Connecting External Speakers - Sharp LB-1085 Mode D'emploi

QUICK REFERENCE

Connecting External Speakers

L
R
SPEAKER R terminal
To external speaker (right)
Make sure to connect the speaker jack and cable polarity (
■
The speaker terminals have plus
The cables are also divided into plus and minus.
When connecting the left/right speakers, be sure to connect the plus/minus jacks with the correct cables.
CAUTION
• Connect the speaker wires to the speakers first, then to the unit.
• Use speakers with an impedance of 4 ohm as lower impedance speakers can damage the unit.
• Do not mistake the right and the left channels. The right speaker is the one on the right side when you face
the unit.
• Do not let the bare speaker wires touch each other.
8
Speaker Compatibility:
• Be sure to use external speakers with an impedance of 4 ohm and a rated
input of at least 15W.
Connect the ends of the cables to the SPEAKER terminals as shown
below. Connect the leads to the SPEAKER terminals of the same
polarity.
SPEAKER L terminal
To external speaker (left)
and minus polarity.
) properly.
,