Epilation - SilverCrest SED 3.7 G3 Mode D'emploi

Epilation

If the body parts to be epilated are prepared:
1) Rub your hand once more against the growth direction of the
hairs to be removed. Through this the hairs will be raised so that
they can be better captured by the tweezers.
2) Remove the protective cap
3) If necessary, fit the massage roller attachment
head . The massage rollers stimulate the skin and thus ensure
a gentler epilation experience.
4) Press the travel lock
to the desired speed level:
― Level 1: for sensitive areas (armpits and bikini line)
― Level 2: for legs
During operation, the LED light
depilated.
5) Hold the skin tight with one hand.
6) Place the epilator perpendicular to the skin and, without exerting
any pressure, move it against the direction of the hair growth.
Thereby, the side with the speed switch
Do not make back and forth or circular movements.
Always start anew and pass over the body part to be epilated
several times, so that all of the hair is removed.
NOTICE
► It may be that the hair grows back after a few days. The reason
for this is that these hairs were too short to be removed during
the last epilation session.
SED 3.7 G3
from the epilator head
and slide the speed switch
illuminates the skin area being
.
onto the epilator
upwards
must face towards you.
GB │ IE │
35 ■