Mains Power Operation; Battery Operation - SilverCrest SED 3.7 G3 Mode D'emploi

Mains power operation

1) Insert the connector plug of the mains power adapter
socket for mains adapter
speed switch
2) Connect the mains power adapter
The control lamp
process is active.
The appliance is ready for immediate use.

Battery operation

1) Insert the connector plug of the mains power adapter
socket for mains adapter
speed switch
2) Connect the mains power adapter
The control lamp
process is active.
As soon as the control lamp
charged and you can disconnect it from the mains power supply.
NOTICE
► For the initial charging, the appliance requires about 80 minutes
to fully charge.
► First recharge the appliance when the control lamps
by alternately flashing red and green, that the battery charge
level is low.
SED 3.7 G3
on the appliance. Ensure that the
is set at "0".
glows red to indicate that the charging
on the appliance. Ensure that the
is set at "0".
glows red to indicate that the charging
glows green the appliance is fully
to a mains power socket.
to a mains power socket.
GB │ IE
into the
into the
indicate,
│
33 ■