Transpose - Eagletone DPW 400 Guide De L'utilisateur

GROUP
PIANO
E. PIANO
HARPSICHORD
ORGAN
STRINGS
LAYER VOICE
With the layer mode, you can layer (or mix) two instrument sounds together.
Press the LAYER button to engage the dual voice mode; its indicator lights up. The display shows the
layered voice number (the default layered voice is Strings). If the LAYER button and a voice selection
button are pressed simultaneously, the layer voice mode is also engaged, but the LAYER indicator
flashes. Then, use the voice selection button, the VARIATION or the ▲/▼ buttons to select the layer
voice.
If you press any button except ▲/▼ and the voice selection buttons, or if there is no manipulation for 3
seconds once the selection is over, the display returns to the voice selection mode and shows the master
voice. The LAYER indicator stays lit.
Press the LAYER button again to exit the layer voice mode; its indicator turns off.
The volume balance between the layer voice and the master voice can be adjusted. Please refer to the
FUNCTION chapter for details.
The TRANSPOSE feature can shift the pitch of the piano up or down in semitone intervals.
Press the TRANSPOSE button to engage the Transpose feature. Its indicator blinks. The display
shows the current transpose value (the default value is 0) with the prefix «t» in front. Use the ▲/▼
buttons to set the Transpose value, ranging from -6 to 6, e.g. t-5. If you press any button except ▲/▼ or if
VOICE LIST
N°
01
02
03
04
05
06
07
08
09
10
11
12
13 Strings Ensemble
14
15

TRANSPOSE

VOICE
Grand Piano
Grand Piano 2
Honky Tonk
E. Piano 1
E. Piano 2
Vibraphone
Harpsichord
Clavinet
Nylon Guitar
Church Organ
Jazz Organ
Rock Organ
Slow Strings
Synth strings
MIDI No
0
1
3
4
5
11
6
7
24
19
16
18
48
49
50
10