Control Panel And Pedals; Front Control Panel; Bottom Panel - Eagletone DPW 400 Guide De L'utilisateur

CONTROL PANEL AND PEDALS

FRONT CONTROL PANEL

Master Volume Voice select Display Record Song
Reverb, Chorus, Layer, Duet
Setup, Demo, Metro, Trans, Tempo
See detailed description of the control panel in the following chapters.
POWER SWITCH : The power switch is located on the left of the keyboard. Press the button to turn the
power on and off. The red power indicator located on the left of the front cross bar lights up when the
power is on.
NOTE :
lorsque vous éteignez l'instrument, ne le rallumez pas immédiatement. Attendez au moins cinq
secondes afin que les circuits électroniques se réinitialisent correctement.

BOTTOM PANEL

The socket board is located on the front-left section of the bottom.
The headphones jack board is located on the front and on the left of the bottom.
See detailed description of the panel in the GETTING PREPARED TO PLAY chapter
PEDALS
1. SOFT PEDAL – When the left pedal is engaged the piano volume is reduced and the timbre is slightly
altered on the notes that are played.
2. SOSTENUTO PEDAL – The function of this pedal is similar to the sustain pedal. When notes are played
while the middle pedal is engaged, the notes are sustained. The sustain effect does not apply to the notes
played after the pressing of the pedal, even though the pedal is kept engaged.
3. SUSTAIN PEDAL – When the right pedal is engaged, the piano keys will continue to sustain as they are
played. Thereby the piano notes will decay gradually as if you were continuing to hold down the piano keys.
7