3.4 Battery change
•
Two 1,5V AA batteries are required.
•
The battery compartment is below the pouch.
•
Simply remove the pouch from the compartment during battery change.
•
Unscrew the battery lid.
•
Remove old batteries and dispose of in accordance with applicable federal,
state/provincial and local regulations and directive.
•
Replace with new batteries. Pay attention to the correct orientation of each
battery.
•
Close the compartment and secure the lid with the screw.
•
Do not expose batteries to direct sunlight, heat or fire.
There is a risk of explosion!
4. Use
Every Easy-Click pole section has its own activation button to start the pump.
It's most useful to use the lowest button that is close to your lower hand.
Because the TriPad is made from high performing microfibre material, you don't
need to use much of the Glass Cleaner. Use as little liquid as possible during the
cleaning process.
1. Start the cleaning by moving the TriPad over the window. It only needs to be damp to achieve the best
cleaning results. For stubborn dirt, hold the activation button for about 1 second per square metre.
At the green microfibre TriPad (SRPD1) we recommend for a comfortable handling to press the activation
button for four seconds to pre-moisten the TriPad. Use circular motions over the window to dampen the
entire surface of the TriPad.
2. Start by cleaning the window frames. Turn the right edge of
the TriPad to next frame side and move it to the next corner.
Turn again the edge to next frame, move down and repeat
that for all 4 corners of the window.
3. Clean the inner area of the window. You can clean from side
to side or from top to bottom. Always turn the triangle head to
the side beyond.
10
Stingray
Installation / Use
www.ungerglobal.com/stingray
Cleaning System
®
2
3