Battery Change; Use - unGer STINGRAY Guide D'utilisation

Installation/Use

3.4 Battery Change

• Two AA batteries are required.
• The battery compartment is located under the pouch.
• Remove the pouch from the compartment during battery change.
• Unscrew the battery lid.
• Remove old batteries and dispose of in accordance with applicable
federal, state/provincial and local regulations.
• Do not mix old and new batteries. Do not mix different types of batteries
such as non-rechargeable and rechargeable.
• Replace with new batteries. Pay attention to the correct
orientation of each battery.
• Close the compartment and secure the lid with the screw.
• Do not expose batteries to direct sunlight, heat or fire.

4.0 Use

Every pole section has its own activation button to start the pump.
1. Before beginning a new cleaning job or when using a new pad, press pad
flat against the window and press the activation button for a maximum
five seconds to pre-moisten the pad. Use circular motions to dampen the
entire surface of the pad. During the cleaning process, use as little liquid
as possible. If you need to re-moisten the pad, hold the trigger or activation
button for about one second.
Pad only needs to be damp to achieve the best cleaning results.
2. When window cleaning, start by cleaning the window frames. Beginning in
one corner, clean the outer edge of the window being sure to keep contact
with the frame.
3. Once outer area is cleaned, in all four corners and along all four edges,
clean inner area of window.
2
6
1
5x
3
or