Metabo HPT CR 10DL Instructions De Sécurité Et Mode D'emploi page 16

English
CAUTION:
Never apply any unreasonable force to the saw
blade when cutting. Also remember to press the
base against the lumber firmly.
4. Sawing curved lines
We recommend that you use the BIMETAL blade
mentioned in Page 18 for the saw blade since it is
tough and hardly breaks.
CAUTION:
Delay the feed speed when cutting the material
into small circular arcs. An unreasonably fast feed
may break the blade.
5. Plunge cutting
With this tool, you can perform pocket cutting on
plywood panels and thin board materials. You can
carry out pocket cutting quite easily with the saw
blade installed in reverse as illustrated in Fig. 26,
Fig. 28, and Fig. 30. Use the saw blade that is as
short and thick as possible. We recommend for this
purpose that you use BI-METAL Blade No. 107
mentioned in Page 18. Be sure to use caution during
the cutting operation and observe the following
procedures.
(1) Press the lower part (or the upper part) of the base
against the material. Pull the switch trigger while
keeping the tip of the saw blade apart from the
material. (Fig. 25, Fig. 26)
(2) Raise the handle slowly and cut in with the saw blade
little by little. (Fig. 27, Fig. 28)
(3) Hold the body firmly until the saw blade completely
cuts into the material. (Fig. 29, Fig. 30)
Fig. 25
Fig. 27
Fig. 29
16
6. Using the light
7. Battery level warning lamp
Fig. 26
Fig. 28
NOTE:
Fig. 30
CAUTION:
Avoid plunge cutting for metallic materials. This
can easily damage the blade.
Never pull the switch trigger while the tip of the
saw blade is pressed against the material. If you
do so, the blade can easily be damaged when it
collides with the material.
Make absolutely sure that you cut slowly while
holding the body firmly. If you apply any
unreasonable force to the saw blade during the
cutting operation, the blade can easily be damaged.
Pull the trigger switch to light up the light. The light
keeps on lighting while the trigger switch is being
pulled. The light goes out after releasing the trigger
switch. (Fig. 31)
Light
Trigger switch
Fig. 31
CAUTION:
Do not look directly into the light. Such actions
could result in eye injury.
The battery level can be checked by pulling the
trigger switch while the power tool is in a no-load
state. The battery level warning lamp lights when
the battery power is very low. If this happens, charge
the battery. (Fig. 32)
Fig. 32
The level at which the battery level warning lamp
lights may vary due to the ambient temperature,
characteristics of the battery, etc. and is intended
only as a guide.
Battery level
warning lamp