Changeing The Carbon Brush; Storaging; Cleaning; Disposal - Zipper Maschinen ZI-KS210 Mode D'emploi

15.3 Changeing the carbon brush

If the motor becomes loud or even does not start anymore,
the carbon brushes are probably worn.
If the carbon brush is worn (<4mm) you need to replace the
2 carbon brushes. It is no warranty case.
Memorize the direction of the carbon brushes when removing
them.
 Open the carbon brush holder (1) at the motor (2).
 Change carbon brush (3)
 Close the carbon brush holder

15.4 Storaging

The machine never store outdoors!
Storage permitted only at temperatures between + 5 ° and + 40 ° C, with at + 40 ° C the humidity
must not be higher than 60%.
Store in a dry, clean place.

15.5 Cleaning

After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do not
remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal surfaces
as well as the use of scrubbing agents will damage the machine surface!
Clean the machine surface with a wet cloth soaked in a mild detergent
Put on all coatless flats a thin coat of oil.

15.6 Disposal

Do not dispose the machine in residual waste. Contact your local authorities for information
regarding the available disposal options. When you buy at your local dealer for a
replacement unit, the latter is obliged to exchange your old.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-KS210
N O T I C E
MAINTENANCE
32