Zenoah GZ3500T Manuel D'utilisation page 30

equipped with the below listed guide bar and saw chain
combinations.
Low kickback saw chain
A saw chain that is designated as Low kickback saw
chain, meets the low kickback requirement specified in
ANSI B175.1-2012.
Guide bar
Length, in/mm Pitch, in
14/36 3/8 mini
Filing equipment and filing angles
Use a Zenoah file gauge to sharpen the saw chain. A
Zenoah makes sure that you get the correct filing
angles. The part numbers are given in the table below.
H37 5/32 in / 4 mm
30
Gauge, in/mm Max. nose ra-
dius
0.050/1.3 7T
579 65 36-01
Kickback and guide bar nose radius
For sprocket nose bars the nose radius is defined by the
number of teeth (for example 10T). For solid guide bars
the nose radius is defined by the size of the nose radius.
For a given guide bar length, you may use a guide bar
with smaller nose radius than listed.
Saw chain
Type
Zenoah H37
If you are not sure how to identify the type of saw chain
on your product, refer to www.zenoah.com for more
information.
0.025 in / 0.65
mm
Length, drive Low Kickback
links (no.)
52 Yes
30° 80°
308 - 007 - 05.11.2019