Fujitsu Siemens Computers ACTIVY 150 Manuel De L'utilisateur page 104

ACTIVY Media Player 150
Welcome screen
Setup Wizard welcome screen. Press OK on the
remote control to proceed to the next screen.
Please note that, from this point, your UpnP
server should be switched on and available in
the network.
Personalise your Media Player
If you wish to change the name of the Media
Player, press OK on the remote control to
display the on-screen keyboard (see also
chapter 5.4). To proceed to the next page use
the down arrow on the remote control to
navigate to the Next button and then press OK.
Select your network connection
The default network connection type is Wired.
Wired network connection
Press the down arrow on the remote control to
navigate to the Next button. Once the Next
button is highlighted, press the OK button on the
remote control to proceed to the next screen.
Wireless network connection (WLAN)
To configure a wireless network connection,
press the OK button on the remote control while
the Connection field is highlighted. Then press
the down arrow to select WLAN. Press OK
again to confirm the selection and press the
down arrow to navigate to the Next button.
Press OK to proceed to the next screen. The
remaining steps to configure a wireless
connection are shown below.
The ACTIVY Media Player 150 will automatically scan for any Wireless Access
Points nearby and display these.
18