Replacing The Remote Control Battery; Disposal Of Used Batteries - ClassicFlame 39EB500ARA Manuel D'instruction

REPLACING THE REMOTE CONTROL BATTERY

When the remote control stops operating or its range
seems reduced, it is time to replace the battery with a
new one.
1. The battery compartment is located on the back end
of the remote.
2. Press and slide the battery door open and remove the
old battery.
3. Insert a CR2032 battery, checking that the "+" and "-"
terminals of the battery matches the inside of the battery
compartment.
4. Replace the battery compartment door.

DISPOSAL OF USED BATTERIES

Battery may contain hazardous substances
which could endanger the environment
and human health.
This symbol marked on the battery and/
or packaging indicates that used battery
shall not be treated as municipal waste.
Batteries should be disposed of at an
appropriate collection point for recycling.
By ensuring the used batteries are disposed of correctly, you will help preventing
potential negative consequences for the environment and human health. The recycling
of materials will help to converse natural resources.
For more information about recycling of used batteries, please contact your local
municipality waste disposal service.
WARNING: Make sure the power is turned off before proceeding. Any electrical repairs or
rewiring of this unit should be carried out by a licensed electrician in accordance with
national and local codes.
If repairing or replacing any electrical component or wiring, the original wire routing, color
coding and securing locations must be followed.
WARNING: Electrical outlet wiring must comply with local building codes and other applicable
regulations to reduce the risk of fire, electrical shock and injury to persons.
WARNING: Do not use this fireplace if any part of it has been under water. Immediately call a
qualified service technician to inspect the fireplace and replace any part of the electrical system.
Warning: Disconnect power before attempting any maintenance or cleaning to reduce the risk
of fire, electrical shock or personal injury.
Warning: During any service of this appliance, the power to the unit must be turned off.
First turn the main power switch to the "OFF" position. Then remove the electrical plug from
the wall outlet.
NOTE: PLEASE OPERATE REMOTE TRANSMITTER AT A SLOW
MEASURED PACE. PRESS THE REMOTE CONTROL BUTTONS
WITH AN EVEN MOTION AND GENTLE PRESSURE. REPEATEDLY
PRESSING BUTTONS IN RAPID SUCCESSION MAY CAUSE THE
TRANSMITTER TO MALFUNCTION.
E-6
Figure 5
HEAT
TEMP FLAME
DOWN
EMBERS
LIGHT
TIMER