Control Panel Functions - ClassicFlame 39EB500ARA Manuel D'instruction

CONTROL PANEL FUNCTIONS

TO ACCESS CONREOL PANEL - Open the front glass
doors, then slide the mesh curtains to the sides. Lift the
hinged door that covers the control panel (figure 3).
Note:
The 2 switches located at the lower right of the emberbed
must be in the ON position to operate any functions
of the fireplace.
- POWER
The POWER button supplies power to all of the functions
of the fireplace. The POWER button will put the insert
in a standby mode. This will turn off all functions at
once but will hold the settings in the memory. By
pressing the POWER button again the unit will turn on
at the same settings.
NOTE: Holding the POWER button on the control panel
for 10 seconds will disable the heater function.
FLAME (▲ ▼) -
There are 6 flame settings that can be selected.
EMBERS -
Adjust undulating emberbed effect. There are 3 levels including the OFF setting.
HEATER (▲ ▼) -
The ▲ ▼ buttons will change the thermostat by 1 °F (1 °C.)
The temperature setting range is 59 °F - 86 °F (15 °C and 30 °C).
NOTE: To change between °F and °C press and hold the HEATER button on the control panel for 10 seconds.
NOTE: After the heater function or power is shutoff the blower will continue to run for several minutes to cool the
internal components.
TIMER -
The TIMER button will cycle through the 10 timer settings (30 minutes, 1 Hour, 2H, 3H, 4H, 5H, 6H, 7H, 8H,
and 9H) and the OFF setting.
DOWNLIGHT -
There are 2 selectable settings and OFF. Setting 1 is constantly on and setting 2 change intensity to
mimic a real fire.
SECTION 4: OPERATION
EMBERS
FLAME
ON
HEATER
E-5
Figure 3
Control Panel
DOWN
TIMER
LIGHT