General Safety Instructions; Sources Of Danger; Improper Usage - Wetrok Monovac 6 Plus Mode D'emploi

1 GENERAL SAFETY INSTRUCTIONS

This machine is designed and constructed according to the present state of the art and recognized technical safety standards. It is electrically tested and
satisfies European Safety Standards. It is fitted with a safety device in the form of a circuit breaker. Dangers can occur in spite of this, in particular in the
case of improper use or non-compliance with the specifications and instructions in these operating instructions.

1.1 Sources of danger

Electric voltage / electric current
Warning: Danger!
Contact with voltage or current bearing parts carries the risk of electric shock, which can result in serious injury or even death. Never touch damaged
cables. Always switch off and disconnect the power supply before carrying out any work on the machine. Replace faulty cables immediately.

1.2 Improper usage

Any usage of the machine for a purpose not covered under the „Prescribed usage" or the contractually agreed purpose is not permissible.
The use of the machine in an unserviceable condition or not in compliance with the following prescriptions is prohibited:
• Protective devices shall not be removed or bypassed
• Conversions and modifications to the product are not permitted
• Defective supply cables are only to be replaced flexible sheathed cables H 05 VV-F .
• The machine shall be fitted with a type H circuit breaker for a rated current of 6A or a 6 A fuse link.
1.3 Organizational points
It is the responsibility of the operator to ensure that:
• the machine is used only by personnel who have been instructed in its handling and authorized to use it.
• the recognized occupational safety regulations are observed.
• any further national or company regulations are observed.
• all users are acquainted with the safety regulations and trained in the use of the specific machine.
• all users have read and understood the operating instructions before using the machine.
• responsibilities for the operation, maintenance and repair of the machine are clearly assigned and observed.
• faults and damage are immediately notified to the Wetrok Service Agent.
1.4 Emergencies
In the case of an emergency:
• Pull out the mains connector plug.
• Immediately apply recognized first-aid measures
After incidents, do not resume operation with the machine until it has been inspected by Wetrok.
1.5 Operating for the first time
Delivery, instruction on safety rules, handling and maintenance, as well as operation for the first time are normally carried out by a specialist approved
by Wetrok. Where this is not the case, the operator is responsible for instructing the users. Further safety instructions concerning operating and mainte-
nance are detailed in the relevant sections and must be complied with without fail!
30