Before Using - Bartscher FW 80 Mode D'emploi

Components
Universal mincer attachment (A)
Locking ring
1.
Plate
2.
Knife
3.
Worm
4.
Housing
5.
Pusher
6.
Funnel feeder
7.

Before Using

Clean all parts before first use (see chapter
cleaning).
Assembling
Push the worm (4) into the housing (5).
Put the knife (3) with the cutting edges
looking outside the housing onto the worm.
- 8 -
Motor unit (B)
Carrying handle
8.
Power indicator light
9.
ON/OFF switch
10.
Fixing screw
11.
Power cord
12.
Identification plate
13.
Overload safety switch
14.
Assembling (cont.)
After that assemble the plate (2) regarding
the notch is corresponding with the pin at
the housing.
Then fasten the locking ring (1).
Insert the universal mincer attachment onto
the motor unit. Locate it properly by a light
reciprocating turning until the pin engages
onto the groove at the motor unit. Only then
tighten the fixing screw (11).
At least add the funnel feeder (7) and keep
the pusher (6) ready.