Using Effects; Vibrato Or Chorus; Reverb - Key B Organ viscount Legend Mode D'emploi

User Manual

5.1 VIBRATO OR CHORUS

In the VIBRATO/CHORUS section of the front panel there are three controls designed to apply the desired
effect (Vibrato or Chorus) to the sound. The Vibrato cyclically modulates the pitch of the signal thus adding
"spatiality" and "full-body" to the sound. Chorus adds the direct signal to the modulated signal. As a result, it
affects both the signal's tuning and amplitude.
LEGEND and LEGEND CLASSIC
Through the tab [VIBRATO SWELL ON/OFF] (Legend and Legend Classic) or [VIBRATO/CHORUS UPPER]
(Legend Live) you can modulate the upper manual sound. To add the effect to the lower manual and the
pedalboard, use the [VIBRATO GREAT ON/OFF] tab (Legend and Legend Classic) or [VIBRATO/CHORUS
LOWER] (Legend Live).
The six-position knob [VIBRATO AND CHORUS] can be used to select one of the three Vibrato effects (V1-V2-
V3) or the three Chorus effects (C1-C2-C3), which differ in the depth of modulation of the signal.

5.2 REVERB

Reverb originates from the sum of the various acoustic reflections produced by a sound in a natural
environment. In the original electromagnetic organs, the reverb was simulated by means of a special device
containing one or more springs. The Reverb effect of the Legend / Legend Classic / Legend Live allows you
to simulate a natural reverb and the reverb characteristic the electromechanical organ.
Through the [REVERB] potentiometer on the side panel of the upper manual you can adjust the
reverb level.
Select the reverb type with the [REVERB HALL/SPRING] button. In HALL mode the led is
switched off. This reverb simulates a closed room. In SPRING mode the led is on; this mode
simulates the typical spring reverb.
With the [REVERB POST/PRE] button (only available in Legend and Legend Classic model)
you can select the position of the effect in the signal chain. In POST mode the led is off; the reverberation is
added after the Rotary effect. In PRE mode the led is on; the reverberation is applied before the Rotary
simulation effect.
In Legend Live model press simultaneously the button [TRANSPOSE SELECT] and the key G4 on the upper
manual to select the POST mode. Press [TRANSPOSE SELECT] and the key A4 instead, to select the PRE
mode.
NB
Using a rotary speaker connected to the connector [ROTARY SPEAKER] on the rear panel (see point 1 of par. 3.3), in
order to have the internal reverb effect, it is necessary to set the REVERB in PRE mode.

5. USING EFFECTS

EN - 20
LEGEND LIVE