Maintenance - Wolf Garten SDE 2100 Mode D'emploi

Maintenance

General
1
Remove the mains plug before any maintenance and
cleaning work!
When servicing the cutting tool ensure that it can still
always run on even when the motor is switched off.
Wear protective gloves.
Store the appliance in a dry location out of the reach of chil-
dren.
General cleaning information
1
Remove the mains plug before any maintenance and
cleaning work!
Handle the appliance with care and clean it regularly to pro-
long its service life.
Keep the ventilation slits clean and dust-free.
Only use a warm and moist cloth to clean the appliance as well
as a soft brush.
Do not allow the appliance to get wet and do not spray with
water.
Cleaning the collection hopper
1
Remove the mains plug before any maintenance and
cleaning work!
1. Unscrew the knob and fold the casing upwards to open
2. Clean the cutting and discharge area of all objects which could
block the blades.
3. Close the casing again and tighten the knob
4. Press the reset button before activating the ON/OFF switch.
12
Safety locking device
The chopper is equipped with a safety locking device at the
lock between the casing and the motor casing.
In the event that the casing does not close flush to the motor
casing, the motor is stopped by the safety locking device.
In such a case, proceed as follows:
–
Unscrew the knob and fold the casing upwards to open
–
Carefully clean the contact surfaces.
–
Close the casing again and tighten the knob
Changing blades
1
Remove the mains plug before any maintenance and
cleaning work!
When servicing the cutting tool ensure that it can still
always run on even when the motor is switched off.
For safety reasons, always have the blades changed by
an authorised service centre.
1. Unscrew the knob and fold the casing upwards to open
2. In order to change the blades insert the hexagon spanner
(1) in the slot on the retaining plate and through the cover.
3. Loosen the two screws with the Allen spanner
out the worn blades.
4. Insert the new blades and tighten the screws.
1
Remove both the Allen and hexagon spanner after com-
D .
pleting the change.
5. Close the casing again and tighten the knob
D .
D E
D
D
.
D
.
D .
E
E (2) and take
.
G