BoomToneDJ PARZOOM 3x15W Mode D'emploi page 16

DMX Protocole 8 channels:
CH Function
1 Dimmer
2 Strobe
3 Zoom
4 R Dimmer
5 G Dimmer
6 B Dimmer
7 W Dimmer
8 Reset
5. DMX 512 Connection
The DMX 512 is widely used in intelligent lightings and with a maximum of 512 channels.
1. If you using a controller with 5 pins DMX output, you need to use a 5 to 3 pin adapter-cable.
2. At last unit, the DMX cable has to be terminated with a terminator. Solder a 120 ohm 1/4W
resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in the
DMX-output of the last unit.
3. Connect the unit together in a 'daisy chain' by XLR plug from the output of the unit to the
input of the next unit. The cable cannot be branched or split to a 'Y' cable. DMX512 is a very
high-speed signal. Inadequate or damaged cables, solder joints or corroded connectors can
Detail
0-255 :0-100% dimming
1-255; Strobe, from slow to fast
0-255 : Zoom adjustment, from big to small
0-255; 0-100% dimming
0-255; 0-100% Red dimming
0-255; 0-100% Green dimming
0-255; 0-100% Blue dimming
150-200 Reset
16