Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
How to make the batteries perform longer.
Recharge the batteries before they become
completely exhausted.
When you feel that the power of the tool becomes
weaker, stop using the tool and recharge its
battery. If you continue to use the tool and exhaust
the electric current, the battery may be damaged
and its life will become shorter.
Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately
after use. If such a battery is recharged immediately
after use, its internal chemical substance will
deteriorate, and the battery life will be shortened.
Leave the battery and recharge it after it has cooled
for a while.
BEFORE USE
Check the work area to make sure that it is clear of debris
and clutter.
Clear the area of unnecessary personnel. Ensure that
lighting and ventilation is adequate.
PRIOR TO OPERATION
1.
Confirming condition of the environment
Confirm that the work site is placed under
appropriate conditions conforming to prescribed
precautions.
2.
Attaching the side handle (Fig. 6)
(1) Turn the grip of the side handle to loosen it and
push it in until it comes in contact with the housing.
(2) Adjust the side handle to the angle that allows the
easiest use, then turn the side handle's grip firmly
to lock it place.
Loosen
3.
Mounting the drill bit (Fig. 7)
CAUTION:
To prevent accidents, make sure to turn the switch
off.
NOTE:
When using tools such as drill bits, etc., make sure
to use the genuine parts designated by our company.
Tighten
Fig. 6
(1) Clean the shank portion of the drill bit.
(2) Insert the drill bit in a twisting manner into the tool
holder until it latches itself. (Fig. 7)
The grip need not be adjusted during bit installation.
(3) Check the latching by pulling on the drill bit.
(4) To remove the drill bit, fully pull the grip in the
direction of the arrow and pull out the drill bit. (Fig.
8)
Part of
Drill bit
SDS-plus
Front
shank
cap
Drill bit
Part of SDS-plus
shank
4.
Installation of dust cup or dust collector (B)
(Optional accessories) (Fig. 9, Fig. 10)
When using a rotary hammer for upward drilling
operations attach a dust cup or a dust collector (B)
to collect dust or particles for easy operation.
Installing the dust cup
Use the dust cup by attaching to the drill bit as
shown in Fig. 9.
When using a bit which has big diameter, enlarge
the center hole of the dust cup with this rotary
hammer.
Installing dust collector (B)
When using dust collector (B), insert dust collector
(B) from the tip of the bit by aligning it to the groove
on the grip. (Fig. 10)
English
Grip
Fig. 7
Grip
Fig. 8
13
Publicité
Table des Matières
