Kenmore 110.22532512 Guide D'utilisation Et D'entretien page 16

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

If you experience
Washer Not Performing As Expected (cont.)
Fabric damage (cont.)
Odors
Lid locked light is
flashing
Single-dose laundry
packet not dissolving
Washer pumps out water
before finishing cycle
16
TROUBLESHOOTING
First try the solutions suggested here
for assistance and to possibly avoid a service call.
Possible Causes
Fabric damage can occur if load
is tightly packed. (cont.).
Liquid chlorine bleach may have been
added incorrectly.
Garment care instructions may not
have been followed.
Monthly maintenance not done as
recommended.
Using too much detergent.
The lid is not closed.
A cycle was stopped or paused using
the Start/Pause/Unlock Lid button.
Adding laundry packet incorrectly.
Lid is left open for more than
10 minutes.
Use Bulky/Bedding or Jeans/Towels cycle for higher water fill, or
set Water Level knob to Deep Fill setting. See "What's New Under
the Lid" and "Cycle Guide" to match your load with the best cycle.
NOTE: Deep Fill is not available in the Normal cycle mode.
Selecting the Normal cycle with the Deep Fill setting will result
in auto sensing of the water level.
Add only one or two additional garments after washer has started.
Do not pour liquid chlorine bleach directly onto load. Wipe up
bleach spills.
Undiluted bleach will damage fabrics. Do not use more than
recommended by manufacturer.
Do not place load items on top of bleach dispenser when loading
and unloading washer.
Always read and follow garment manufacturer's care label
instructions. See the "Cycle Guide" chart to match your load with
the best cycle.
See the "Washer Care" section in Washer Maintenance.
Unload washer as soon as cycle is complete.
Be sure to measure correctly. Always follow the manufacturer's
directions.
See the "Washer Care" section.
Close the lid. The washer will not start or fill with the lid open.
The washer may still be spinning. The lid will not unlock until
the basket has stopped spinning. This may take several minutes.
if washing large loads or heavy fabrics.
Be sure laundry packet is added to washer basket before adding
clothes. Do not add packet to dispenser. Follow the manufacturer's
instructions to avoid damage to your garments.
Make sure lid is closed before starting a cycle and/or during
prewash (soak).
Solution

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

110.20232711

Table des Matières