Troubleshooting And Repairs - Starmix Airstar T-C1 M Notice D'utilisation

Safety features
The hand dryer is equipped with the following safety features:
– Safety cut-off sensor after 35 seconds
– Safety temperature limiter in case of overheating, e.g. if outlet opening is blocked
– Thermal fuse in case of overheating
The hair dryer is equipped with the following safety features:
– Safety cut-off sensor after approx. 4 minutes, e.g. in case of chewing gum vandalism
– Safety temperature limiter in case of overheating, e.g. if outlet opening is blocked
– Thermal fuse in case of overheating
5 Conduct in case of emergency
In cases of fire hazard, electrical shock, mechanical damage, unusual operating conditions or misuse, proceed as
follows:
1. Unplug power cord. With fixed connection: Switch off circuit breaker or unscrew fuse.
2. Secure against accidental switching on.

6 Troubleshooting and repairs

Malfunction
The device does not start
Air output is insufficient
Do not take any further action; contact customer service instead.
7 Maintenance
Clean the air intake grille
See Fig. I
Clean the air intake grille at regular intervals, but at least every 6 months. The air intake grille may only be
cleaned by trained specialist personnel.
Cause
Sensor is soiled
Fuse has tripped
Overheating due to blocked outlet
opening
The thermal fuse was triggered
Air intake grille is soiled
Remedy
Remove dirt from sensor and wipe
with damp cloth
Switch on circuit breaker or
replace fuse
Clean out outlet opening, allow
device to cool down
Have thermal fuse replaced by
customer service
Clean air intake grille
en
21