Device Structure - Starmix Airstar T-C1 M Notice D'utilisation

2 Device structure

See Fig. A
1 Device
2 Mounting plate
3 Sensor
4 Outlet opening
3 Installation
Unpacking
1. Take all parts out of the packaging.
Scope of delivery:
1 Device
4 Screws
4 Dowels
Installing the device
See Fig. B, C, D, E
CAUTION
Unsuitable installation material and tooling!
Risk of injury caused by the device falling down.
Before installation:
1. Check if screws and dowels supplied with the device are suitable for the surface material.
2. Have suitable tools to hand for installation.
Preparation (see Fig. B, C):
1. Select a wall with a sturdy, weight-bearing surface.
2. Observe installation height and minimum distances.
3. Have suitable fastening material to hand for installation on the wall.
Remove hood from the device (see Fig. D):
1. Loosen upper two fastening screws of the hood.
2. Loosen lower two fastening screws of the hood.
3. Remove hood from the mounting plate.
4. Disconnect protective earth wire (PE) of the hood from the terminal. NOTICE! Do not open the screw on
the metal hood.
Fasten mounting plate to the wall (see Fig. E, F):
1. Hold drilling template or mounting plate against the wall and mark the drill holes.
2. Drill the holes.
3. Insert electrical connection cable into cable duct of the mounting plate (see Fig. F) and fasten the mounting
plate to the wall.
5 Air intake grille
6 Locking screw
7 Motor protection filter
1 Offset screwdriver TX25
1 Drilling template
1 Instruction manual
en
19