Triton JOF001 Instructions D'utilisation page 10

TROUBLESHOOTING
The following chart contains information designed to assist in diagnosing and resolving router problems.
SYMPTOM
Router will not operate
Router runs slowly
Makes an unusual sound
Excessive Vibration
Heavy sparking occurs
inside motor housing
Shutter on power
switch not releasing
Can't plunge to
collet lock position
GB
Troubleshooting
10
POSSIBLE CAUSE
No supply of power
Brushes worn or sticking
Switch is faulty
Motor components faulty or short circuited
Blunt or damaged cutter
Variable speed set low
Motor is overloaded
Mechanical obstruction
Armature has shorted sections
Bent cutter shank
Brushes not moving freely
Armature short circuited or open circuited
Commutator dirty
Router is plunged to full depth – in collet lock
position
Power switch "On"
REMEDY
Check power is available at source
Disconnect power, open brush caps and ensure brushes
move freely in the holders. Check whether the brushes require
replacing - see 'Brush Replacement'
Go to www.tritontools.com for your
nearest Triton Approved Service Agent
Re-sharpen or replace cutter
Increase variable speed setting
Reduce pushing force on router
Go to www.tritontools.com for your
nearest Triton Approved Service Agent
Replace cutter
Disconnect power, remove brushes, clean or replace
Go to www.tritontools.com for your
nearest Triton Approved Service Agent
Reduce plunge depth
Switch power 'Off'