Installation And Use; First Check; Warranty; Assembly - Fisso 6646 Série Mode D'emploi

Installation and use

First check

Check the product immediately after receipt for eventual transport damages and for completeness. Complaints
can only be considered if the manufacturer, distributor or carrier is immediately notified through damage
protocol.

Warranty

The manufacturer assumes warranty for materials and manufacturing defects as well as proper functioning of
FISSO holding systems for 24 months from date of purchase.
Not covered by the warranty are normal wear, components with a shorter life time (e.g. arm pads), the
consequences of inappropriate handling, combinations with external products, or damage caused by the user.
Other or further claims, in particular any claims for damage are excluded. The warranty applies only if the
Baitella AG repair service is used. Please see also the Sales and General Delivery Conditions.

Assembly

WARNING
All handling must be done with as little force as possible and as much force as
necessary!
WARNING!
The assembly and handling of the products must be done manually and without
additional tools.
Pos. 2
Pos. 1
Pos. 5
Pos. 4
Pos. 2
Pos. 1
Pos. 3
WARNING!
If the base / column is not correctly tightened, it may become loose and may cause injuries
to the patient.
WARNING!
Close the gear coupling in such a manner, that the teeth grasp into each other and that
they do not stand on each other.
EN
Arm support lateral:
Attach the base to the side rail of the surgical table and secure it by turning the
fastening screw (Pos. 1) from below clockwise. Please note that the top hook
(Pos. 2) grasps behind the rail. Check if the base is fixed securely and firmly on the
side rail.
Arm support vertical:
Mount the base in the same way described for arm support lateral, see above.
Remove the stop lid (Pos. 3) and insert the column (Pos. 4) into the opening of the
radial setting clamp. Fix it with the fastening handle (Pos. 5). Mount the stop lid.
Check if the column is fixed securely and firmly into the base.
The column can be adjusted for height and inclination.
19