DigiSender DG300 Guide D'installation page 12

DG300 - DigiSender® Long Range Video Sender System
continued...
3. Channel Scanning Installation for 2 or more Transmitters
In this mode the receiver will cycle through all selected Audio/Video Channels and
display the receiving channel number. Simply select the channel numbers being
used by Transmitters as shown.
Transmitter 1 Transmitter 2 Transmitter 3 Transmitter 4 Receiver
Default dwell time is 1 second per channel, this means each channel will be presented on screen
for 1 second before the next channel is presented.
To change the dwell time for the Audio/Video Channel cycle, do the following
while pointing your DigiSender® remote control at the DigiSender® DG300
Receiver.
For a 1 second delay: Press button 1, three times and the Reciever will display the number 8.
For a 3 second delay: Press button 2, three times and the Reciever will display the number 8.
For a 5 second delay: Press button 3, three times and the Reciever will display the number 8.
For a 7 second delay: Press button 4, three times and the Reciever will display the number 8.
Online Support at www.digisender.net
Page 12