Stihl TSA 230 Notice D'emploi page 30

English
Power consumption: 570 W
Charge current: 12 A
Insulation: II, E (double
insulated)
Abrasive wheels
The quoted maximum permissible
operating speed of the abrasive wheel
must be greater than or equal to the
maximum spindle speed of the cut-off
machine used.
Max. spindle speed:
Outside diameter:
Max. thickness
Bore diameter/spindle
diameter:
Tightening torque:
Composite resin abrasive wheels
Minimum outside diameter
of thrust washers:
Max. depth of cut:
Diamond abrasive wheels
Minimum outside diameter
of thrust washers:
Max. depth of cut:
Weight
without battery, without
abrasive wheel, with water
connection
28
Water supply
Max. pressure of water
supply:
Transport
STIHL batteries fulfill the requirements
stated in UN-Manual
ST/SG/AC.10/11/Rev.5 Part III,
Subsection 38.3.
The user can transport STIHL batteries
by road transport to the place where the
6650 rpm
machine is to be used without additional
230 mm
requirements.
(9 ")
The lithium ion batteries included are
3 mm
subject to the provisions of the
22.23 mm
legislation relating to dangerous goods.
(7/8 ")
When shipped by a third party (e. g. air
20 Nm
transport or haulage firm), special
(177 lbf. in.)
packaging and identification
requirements must be observed.
80 mm
When preparing the item for shipment, a
(3.150 in.)
dangerous goods expert must be
70 mm
consulted. Please observe any further
(2.756 in.)
national regulations.
Pack the battery so that it cannot move
inside the packaging.
80 mm
(3.150 in.)
Further transport instructions - see
70 mm www.stihl.com/safety-data-sheets
(2.756 in.)
EMC Compliance Statement for power
tool and charger
This Class B digital apparatus complies
with Canadian ICES-003.
3.9 kg
(8.6 lbs.)
4 bar
(58 psi)
TSA 230