Stihl TSA 230 Notice D'emploi page 23

During Operation
The green LEDs glow continuously or
flash to indicate the state of charge.
80 - 100 %
60 - 80 %
40 - 60 %
20 - 40 %
0 - 20 %
If the LEDs on the battery flash or glow
red – see "If the red LEDs glow
continuously / flash".
TSA 230
If the red LEDs glow continuously / flash
A
B
C
D
A 1 LED glows Battery is too
1) 2)
continuously hot
red:
B 4 LEDs flash Malfunction in
red battery
C 3 LEDs glow Power tool is too
continuously hot – allow it to
red: cool down.
D 3 LEDs flash Malfunction in
red power tool
1)
When charging: Charge process
starts automatically after the battery
has cooled down / warmed up.
2)
During operation: Power tool cuts
out – allow battery to cool down; it
may be necessary to take the
battery out of the power tool for this
purpose.
3)
Electromagnetic interference or
fault. Take the battery out of the
power tool and refit it. Switch on the
machine – if the LEDs continue to
flash, the battery has a malfunction
and must be replaced.
4)
Electromagnetic interference or
fault. Take the battery out of the
machine. Use a blunt tool to
remove dirt from the contacts in the
battery compartment. Refit the
battery. Switch on the power tool –
if the LEDs still flash, the power tool
has a malfunction and must be
checked by a servicing dealer –
STIHL recommends an authorized
STIHL servicing dealer.
1)
/cold
3)
4)
English
21