Stihl TSA 230 Notice D'emploi page 14

English
against the workpiece anew – the
cutting depth for each operation
should not exceed 2 cm. Cut thicker
material in multiple passes
Cutting plates
Secure the plate (e. g. on a non-slip
N
surface, sandbed)
Cut a guide groove (A) along the
N
line marked
Make the cut (B) deeper
N
Leave a "hinge" (C)
N
First sever the plate at the cut ends
N
so that no material breaks away
Break plate
N
12
Make curves in multiple passes –
N
make certain that the abrasive
cutting wheel does not tilt
Cutting pipes, round and hollow bodies
Secure pipes, round and hollow
N
bodies against vibrations, slipping
and rolling away
Note direction of fall and weight of
N
the severed part
Determine and mark the cutting
N
line, avoid reinforcements,
especially in the direction of the
severing cut
Determine sequence of severing
N
cuts
Cut a guide groove along the line
N
marked
Make cut deeper along the guide
N
groove – observe the recommended
cutting depth for each operation –
for small corrections of direction, do
not tilt the abrasive cutting wheel,
but always position it anew instead –
if necessary, leave small ridges that
hold the part that is to be separated
in position. Break these ridges after
the last planned cut
Cutting concrete pipe
The procedure is dependent on the
outer diameter of the pipe and the
maximum possible cutting depth of the
abrasive cutting wheel (A).
Secure pipe against vibrations,
N
slipping and rolling away
Note weight, tension and direction
N
of fall of the part to be severed
Determine and mark direction of cut
N
Determine sequence of cuts
N
TSA 230