Set Bore Diameter From 65 Mm Diameter; Setting Guide Elements From 65 Mm Diameter - Komet KUB V46 Mode D'emploi




  

3. Set bore diameter
from 65 mm diameter
From bore diameters of 65 - 81 mm the insert
seating  for the external insert can be set
1 mm in the diameter.
• Locate drill head on centering spigot  in
chuck 
• Loosen the clamping screw  for the insert
seating and then tighten again very slightly
• Using the adjusting screw , set the required
bore diameter
• Clamp the insert seating  with the clamping
screw 


4. Setting guide elements
from 65 mm diameter
• Loosen the holding screw 
• Adjust guide elements  with key 
(x 65-81 mm) to diameter D1 (see section)
• Please note that diameter D1 should be 0.2 mm
±0.05 mm less than the bore diameter D as
set
• Secure guide element  with holding screw

Please note:
Before using the tool check if holding screw 
is firmly seated because of possible movement
on the non-ferrous pressure piece .
Please see notes on safety (page 13)!
ENGLISh
11