Installation
GB
IE
WARNING! RISK OF FIRE!
►
Never place the appliance beneath wall
cabinets or adjacent to curtains, wall units
or other fl ammable objects.
►
Always ensure a minimum clearance between
the appliance and hanging cupboards, ceil-
ings, walls or similar of at least 10 cm above
the appliance and 5 cm at the sides. For this
reason the appliance may not be used, for
example, in cupboards or similar. Otherwise
there is likely to be insuffi cient ventilation for
the appliance, which could result in fi re or
damage.
►
Always place the appliance on a heat-resist-
ant surface. Failure to do so increases the risk
of fi re or of the appliance being damaged.
The surface under appliance may become
discoloured and be damaged. Additionally,
permanent indentations could arise if the
appliance is placed on a soft surface.
DANGER – ELECTRIC SHOCK!
►
Do not place the appliance immediately adja-
cent to sources of water, e.g. sinks or basins,
or in damp cellar areas. Otherwise, there is a
risk of receiving an electric shock.
■
Place the appliance on a solid, level and heat-
resistant surface (e.g. stainless steel worktops
or natural stone worktops such as granite).
Ensure there is suffi cient ventilation around the
appliance.
■
Push the appliance up against the wall, with its
rear side facing the wall. The spacers on the
back must touch the wall. Ensure that the wall is
made of heat-resistant material, e.g. tiles, natural
stone or granite.
■
Clean all components as described in the section
"Cleaning and care".
6
Using the appliance
Glass door
CAUTION! PROPERTY DAMAGE!
►
Do not lean on the glass door. Do not place
objects on the glass door. This can cause
damage to the door hinges.
■
Cooking some foods, especially fatty foods,
can result in increased smoke production. In this
case, do not close the glass door completely;
instead, leave it slightly open.
The glass door has a latching position so that
it remains open a little: if you carefully push
the glass door closed, it clicks into this position
shortly before closing completely.
Inserting the crumb tray
Push the crumb tray 8 under the lower heating
■
element so that it rests fl at on the bottom of the
appliance.
Using the rack
WARNING! RISK OF INJURY!
Always use the tongs q to insert the rack 9
►
into the appliance or to remove it.
Push the rack 9 onto one of the 2 rails 1 in
■
the cooking chamber of the appliance.
CAUTION! MATERIAL DAMAGE!
Never place the rack 9 directly upon the
►
heating elements.
If you slide the rack 9 onto the lower rail, pull
■
this out far enough so that the edge lies just
above the extraction hooks 7. Thus, when you
close the glass door, the extraction hooks 7
grip the rack 9 and this is pulled out the next
time you open the glass door.
SGB 1200 A1