Setup & Operation; Before You Start - Haussmann Xpert PNT122 Manuel De L'utilisateur

Quick
Connector
Tool
Quick Coupler
Fig.3
Fig.4
SETUP & OPERATION

BEFORE YOU START

Compatible Compressor & Air Tool - Guidelines for Proper Usage & Operation.
Always ensure the use of appropriately matched air tools and compressors. Be sure
that the air compressor being used can supply the appropriate volume, pressure and
delivery rate of air to the tool(s) without running continuously. Using tools or
combinations of tools that together or separately require more than the air compressor
can deliver will reduce performance and could void the compressor or tool warranty.
AIR SYSTEM (Fig.2)
1. Always use clean, dry, regulated compressed air at 60 to 100 PSI.
2. Do not exceed the maximum and minimum pressures. Operating the tool at the
wrong pressure (too low or too high) will cause excessive noise or rapid wear.
3. Keep hands and other parts of the body away from the tool's discharge and
working areas when connecting the air supply.
4. It is recommended that a filter-regulator-lubricator be used, and that it be located
as close to the tool as possible.
5. If a filter-regulator-lubricator is not installed, place up to 6 drops of compressor oil
into the NPT inlet plug before each use.
6. If a filter-regulator-lubricator is installed, keep the air filter clean. A dirty filter will
reduce the air pressure to the tool, which will cause a reduction in power,
efficiency, and general performance.
7. For optimal performance, install a quick connector to the tool and a quick coupler
on the hose, if applicable.
8. Make sure that all of the connections in the air supply system are sealed in order
to prevent air from leaking.
Quick
Connector
Air Hose
INSTALLING THE SANDER PAD
1. Use self-locking nut (# 31 in part list) to lock swivel shaft (# 37 in part list). (fig.3 &
fig.4)
Filter
Lubricator
Quick
Coupler
Regulator
Air
Compressor
Cut-off
valve
Fig.2
17