Location - GE AE1CD10AM Manuel D'utilisation Et Instructions D'installation

Read these instructions completely and carefully; then follow step by step.
1 SELECT THE BEST LOCATION
A INDOOR UNIT
• Do not allow any heat or steam near the unit.
• Select a location where there are no obstacles
in front of the unit.
• Make sure that condensate drainage can be
conveniently routed away.
• Do not install near a doorway.
• Ensure that the space around the left and right
of the unit is more than 6". The unit should be
installed as high on the wall as possible, allowing
a minimum of 6" from ceiling.
• Use a stud finder to locate studs for mounting and
to prevent unnecessary damage to the wall.
• Install on studs and in a location from which
the condensation water can be drained out
conveniently and that permits easy connection
with the outdoor unit.
• Do not cover the inlet and outlet so that the
outflow air can reach all parts of the room.
• Install in a location that is strong enough to
withstand the full weight and vibration of the unit.
• Be sure that the installation conforms to the
installation dimension diagram.
• Leave enough space to allow access for routine
maintenance. The height of the installed location
should be 79" or more away from the floor.
• Install in a location that is 3 ft. or more away from
other electrical appliances, such as televisions and
audio devices.
• Select a location that gives you easy access to
remove and clean the filter.
More
than 6"
Installation Instructions
More than 6"
More
than 6"
More than 79"
B OUTDOOR UNIT
• If an awning is built over the unit to prevent direct
sunlight or rain exposure, make sure that heat
radiation from the condenser is not restricted.
• Ensure that the space around the back and sides
is more than 12". The front of the unit should have
more than 79" of space.
More than 12"
More than 79"
• Install in a location that is strong enough to permit
safe installation and to withstand the full weight
and vibration of the unit.
• Construct and anchor a strong and level mounting
base or pad for the outdoor unit.
• Anchor the outdoor unit through its four mounts,
using bolts.
• Select a location from which noise and outflow
air emitted by the unit will not inconvenience
neighbors.
• In humid locations, the unit may sweat and
condensation (water) may drip from it. Take this
into consideration when choosing the location.
• Select a location that has sufficient ventilation.
• Do not cover the inlet and outlet.
• Install unit away from flammable gas or corrosive
gas leaks.
• Be sure the installation conforms to the installation
dimension diagram.
•
Rooftop Installations:
If the outdoor unit is installed on a roof structure,
be sure to level the unit. Ensure the roof structure
and anchoring method are adequate for the unit
location. Consult local codes regarding rooftop
mounting.
10
More than 12"
The platform must
support a minimum of
200 lbs. See Installation
Dimensions for mounting
hole spacing.