Electrolux EHL6740F9K Notice D'utilisation page 14

14 www.electrolux.com
7.1 What to do if...
Problem
You cannot activate or op-
erate the hob.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactiva-
ted.
The hob deactivates.
Residual heat indicator
does not come on.
Automatic Heat Up function
does not operate.
The heat setting changes
between two levels.
The sensor fields become
hot.
Possible cause
The hob is not connected
to an electrical supply or it
is connected incorrectly.
The fuse is released.
You touched 2 or more
sensor fields at the same
time.
STOP+GO function oper-
ates.
There is water or fat stains
on the control panel.
You put something on one
or more sensor fields.
You put something on the
sensor field .
The zone is not hot be-
cause it operated only for a
short time.
The zone is hot.
The highest heat setting is
set.
Power management func-
tion is activated.
The cookware is too large
or you put it too near to the
controls.
Remedy
Check if the hob is correctly
connected to the electrical
supply. Refer to the con-
nection diagram.
Make sure that the fuse is
the cause of the malfunc-
tion. If the fuse releases
again and again, contact a
qualified electrician.
Activate the hob again and
set the heat setting in less
than 10 seconds.
Touch only one sensor field.
Refer to "Daily use" chapter.
Clean the control panel.
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
If the zone operated suffi-
ciently long to be hot,
speak to an Authorised
Service Centre.
Let the zone become suffi-
ciently cool.
The highest heat setting has
the same power as the
function.
Refer to "Daily use" chapter.
Put large cookware on the
rear zones if possible.