Power Settings - FTE UNIVERS U4128 Manuel De L'utilisateur

OSD 73
OSD 74
SYSTEM SETUP
NOTE: The default password is 0000
5. Press [Exit] to leave the "Parental Lock" menu.
5.6. POWER SETTING
When you select this option, you will see a screen like beside
(OSD 73):
1. Automatic standby: In this option you can program the auto-
matic turning off of the receiver (OSD 74).
The programming can be made after a period of time between
1 and 8 hours, with 1 h. intervals. The default time is 3 hours.
-On: The receiver will be in standby mode automatically after
this time, as long as during this time no commands have been
sent to the receiver through the remote control or buttons of
the front panel, and no programmed timers are run.
-Off: Auto standby function gets deactivated.
2. LNB Power: If your receiver is connected to the LNB direct-
ly then you need to set the LNB Power to "On". If your receiver
is connected to a multi switch (SMATV signal distribution sys-
tem) then it may be that you don't need to provide the power
to the LNB. But since this is depending on the kind of installed
distribution system we recommend you to contact your install-
er or to refer to the user manual of this system to get the cor-
rect information.
You also just can change this setting and check if you still can
receive the channels. If the LNB Power is off and you still can
see all channels then we recommend this setting.
3. Low Power Consumption: At this option, you could enable
/ disable the low power consumption mode. This mode allows
saving current consumption when the receiver is stand-by.
4. Press [Exit] button to leave this menu.
PAG. 33