Marmitek VIDEOCONTROL3 Guide Utilisateur page 7

You have now successfully installed the VideoControl3. The red LED on the receiver and
transmitter will light up as soon as you transmit a command with your remote control.
Tip 2
The receiver has a adjustment screw which you use to set the sensitivity of the recep-
tion. If the red LED lights up when it is not being activated via the remote control, the
sensitivity is too high. If the LED does not light up when you are using the remote con-
trol, it is set too low. Use a Phillips screw driver to change the setting.
Tip 3
If you want to control your equipment from multiple rooms, you can purchase extra
receivers (Art. No. 9709 (E), Art. No. 9715 (UK).
VIDEOCONTROL3 TM 7