Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
14.
System release procedure
Read carefully the procedure before starting the operation.
The three-digit release Code is printed on the metal plate.
a)
The system is in alarm
b)
Turn the ignition key in ON position
c)
BEGINNING OF CODE COUNT
1.
Turn OFF the ignition key to the number of flashes corresponding to the 1
2.
Turn ON the ignition key to the number of flashes corresponding to the 2
3.
Turn OFF the ignition key to the number of flashing corresponding to the 3
d)
The system is now RELEASED.
NOTE: if the system does not release the LED is STEADY ON
15.
NEW remote control memorization
NOTE: To memorize new remotes, you must have at least 1 remote running of the ones supplied with the alarm
system. This memorization can be done only with system disarmed.
a)
Turn the ignition key in ON position
b)
Turn ON one turn indicator (the right or the left one)
c)
Count 5 flashes
d)
Turn OFF the turn indicator
e)
Push once Button 1 of "running" remote control within 5 seconds
f)
Push 4 times Button 1 of "running" remote control
g)
Turn ignition key in OFF position
h)
Push once the "new" remote control
i)
Push once the "new" remote control
j)
Push once the "old" remote control
k)
Push once the "old" remote control
l)
End of procedure
LED is STEADY ON
LED OFF
COUNT CAREFULLY THE LED FLASHES
4 bleeps will follow as confirmation
2 bleeps will follow as confirmation
2 bleeps will follow as confirmation
2 bleeps will follow as confirmation
2 bleeps will follow as confirmation
test both remote controls are running
SUZUKI GENUINE ACCESSORIES
st
digit of the code
nd
digit of the code
rd
digit of the code
repeat the procedure starting from point b)
4 bleeps will follow as confirmation
5
Publicité
Table des Matières
