Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Prearrangement connector removing: it detects any attempt to remove the alarm system prearrangement connector
on the motorbike.
10. Lifting/movement sensor exclusion
Should the motorcycle be transported with the alarm armed (ferry boat, train, etc), you can cut off the protection of the
position sensor. Press once Button 2 of the remote control during the 40 sec. after the arming ( "Standby Time").
Cutting off is confirmed by 3 bleeps. This function becomes newly operating when the ignition key is turned on again.
11. System alarm
Any violation of the security functions listed under point 9., will lead to an alarm:
siren sounds for 30 sec.
turn indicators flash for 45 sec.
Once the alarm cycle has finished, the system gets ready for a new operation.
12. Alarm memory
The system can store the alarm cause/s by the following LED signals:
1 LED flash every 5 sec.
3
"
"
4
"
"
5
"
"
9
"
"
13. User programmable functions
The system allows the user to program following functions:
System arming bleep (pre-set at factory): acoustic signal alarm system arming/disarming
Turn indicator bleep: simultaneous acoustic signal when turn indicators are flashing
Automatic arming: passive arming when ignition key is turned in OFF position
Programming procedure
1)
Turn the ignition key in ON position
2)
Turn on the turn indicator (the right or the left one)
3)
Count 5 flashes
4)
Turn off the turn indicator
5)
Push once Button 1 of the remote within 5 sec.
6)
Push once Button 1 of the remote control:
7)
Turn the ignition key in OFF position
8)
The system confirms the programmed function as follows:
NOTE: all above functions can be newly operated with the same procedure as above described.
Automatic arming
This function allows the system automatically arming: no need to use the remote. After the ignition key is turned off, 2
bleep confirm that the alarm will be armed after 30 sec. elapse.
This function can be normally excluded by the remote.
Push Button 1 of the remote, before arming, to have this function excluded
confirm the exclusion.
4
lifting / movement
"
ignition key on
"
o.e. saddle pushbutton (if existing)
"
cable cutting / prearrangement connector removing
"
several reasons for alarm
SUZUKI GENUINE ACCESSORIES
4 bleeps follow as confirmation
TWICE
for bleep activation
3 TIMES for turn indicator bleep
6 TIMES for passive arming
2 bleeps for bleep activation
3 "
6
"
for turn indicator bleep
for passive arming
1 bleep + 1 turn indicators flash will
Publicité
Table des Matières
